Corsair dread - Printable Version +- Discovery Gaming Community (https://discoverygc.com/forums) +-- Forum: Discovery Development (https://discoverygc.com/forums/forumdisplay.php?fid=7) +--- Forum: Discovery Mod General Discussion (https://discoverygc.com/forums/forumdisplay.php?fid=37) +--- Thread: Corsair dread (/showthread.php?tid=2699)

Corsair dread - Sid - 04-13-2007 well i had this in my head so i figure id try to draw is for those of ya that whant to see a possble look of what a Corsair dreadknot would look like hears what i came up with, hope those of u that would like to see a possble Corsair dread are happy, took a while but i think it was worth puting my idea in visuals. hope those that wish to see what a possble Corsair dread may look like, like the work i did.:yahoo::cool: Corsair dread - Qunitinius~Verginix - 04-13-2007 Interesting, but I could tell it would have trouble getting through asteroid feidls the way it is now. What program did you use to make that? Verginix out Corsair dread - Sid - 04-13-2007 photo shop. well yea it would have teoble but if the out cast dread comes true then, it will also face a simluar problem. trade lains forget it but for such a nice ship i wouldent mind the problems lol. i have goten a rhineland bs in bad lands once lol. i fell if u must travel through a feild just bonce around lol u eventaly get to ware ya need to lol. i hope they leave the BS mod in the mod it's use full for open areas vers smaler craft. they cnat bump ya lol. Corsair dread - Panzer - 04-13-2007 Whew, I got the original Corsair Dread into the badlands...Memories... Looking good, Sid. Corsair dread - Nightfall - 04-13-2007 Close to my vision Sid. I was thinking more in the lines of only the big wing-like thing. Corsair dread - thekillerppodl - 04-13-2007 looks good but is it me or does it very simlar to a starflier in shape? Corsair dread - gezza999 - 04-13-2007 Its you, that doesn't look anything like a starflier... but it still looks quite nice, though not anywhere near the level that the Starflier's at..