Ingenuus R&D: Lab 002

[Remnant]

The conclusion has been reached, that instead of focusing on the stabilization of the core itself, more attention should be devoted to the actual fixture of the pulsing ball of energy. The fixture was perhaps one of the most important things for keeping it stable and not blowing up everything within a few miles radius. Granted it functioned quite well as it was, although it's been the constant assumption that efficiency has been greatly reduced due to the circumstances that it has been suspended in so far.

Right now, the fixture completely enclosed the core, however the reactions have been slightly harder to study as it's near-impossible to get to the actual device right now. A fixture which will allow open-access to the pulsing ball, but also keeps the energy under control, as for being able to route the energy to the desired locations was the key point for the next area of study.

Of course, something like this would have to be mounted inside of a ship to be able to work efficiently, this would be by no means a temporary structure. Thus implementation will not be done on something like this until there is a place where the core is to be housed permanently, if it is to remain here, that is to be told still.

After weeks of working on an alternative, it's been decided that a ring with metal designed to indirectly draw, and conduct the energy elsewhere is the first change that needs to be done. This would be accomplished by open-air superconductors with small little rods protruding from the metal to draw, and transport the power output.

Working on the idea of air-pressure manipulation to keep an output at a good rate, larger rods will be protruding from the metal, again giving the desired effect which was achieved through the frequency-modulation box which was developed in the past. Perhaps some adjustments can be made, although so far? It's looking quite good.

Prototype fixture

Putting this into practical use, and moving the core over however, would still take some time.