v0.4 is up.
Added some details, cleaned up the mesh, kicked the polycount down to 2.9k (trans) and 3.1k (train). Apparently that's ok for FL engine.
That's the mesh basically done (I'll probably give it another cleanup pass but it wont have much of a noticeable effect on the general look of it). So, if you have any feedback regarding its general look, now would be a good time to post.
Next up is textures.
P.S: If anyone with any clue about FL modeling sees anythin iffy, do point it out. Would be much appreciated. This was the first model I had to do with any sort of tricount constraint, so it could use a pair of more experienced eyes going though it and double-checking just to be sure.
