When Two Rifts Meet

[Starfliers]

---

CHAPTER THREE: THE EXAMINATION

A room similar in scale to Leon's occupies a nearby space next to the Research and Development wing of Starflier base. Within this spartan room is a bed, a table with a single chair and a terminal. The terminal's light illuminates Albert's face as he reads and examines the results of the second remotely activated jump hole generation simulation test.

Epsilon-3

Simulation: Remote Jumphole Generation - Test II

Simulation Parameter: Epsilon-3

Rift Connection Strength: 68%
Rift Destination Accuracy: 91%
Rift Duration: 2.8 seconds

Stabilizer Ring Synchronization: -98%
Stabilizer Ring Gravity Strength: 1,200 units
Stabilizer Ring Rotation Frequency: 10 / minute

Remote Signal Distance: 60,000 m
Remote Signal Strength: 99%
Repeater Required: No
Hardware Issues: No

Custom Jump Drive Survived: Yes
Custom Jump Drive Jumphole Generation Successful: Yes
Custom Jump Drive Reusability After First Activation: Not Recommended

"A negative percentage? I'll reverse that variable..."

A full day was spent on the terminal changing values and setting up custom tests just to see if Albert could stretch the success of Test 2 into a completely successful simulation. A few custom scenarios were denied by the computer, rejecting the simulation due to a guaranteed failure. However, one was accepted by the terminal. A few keystrokes sent the simulation parameter "Starflier-1" to the master simulation platform in the R&D department.

"Very interesting, I'll have to go back to the team with my findings. I may have just figured it out."

---

---

Infopage / Join Us / Index / Discord
Independent Explorers & Researchers.
Return home alive, Pilots.

.