I Haz Outcast Carrierz

[Eppy]

Got back from my choir trip and made some additions as well as a major correction. I have further Eppified the ship, moving the ventral superstructure forward almost to the prow and adding one of my characteristic Maltese anvil-bows. A section of the dorsal arching has been removed and replaced with an observation deck and two additional turret points (bringing the total to eleven; one more may or may not be forthcoming). I've added a sensor unit directly aft of the bridge, and extended the launch bays slightly to accommodate the ribbing I've added as well.

This represents most of the detailing I did; there may be a pair of small dorsal and ventral fins, and I'm seriously considering adding latticework between the two launch bays, but before I could add any of that the model began crashing again. Eventually I broke it in two and poked around; a face delete error brought my attention to the likely source of the crash, which was an error in the rear of the model, funnily enough in the Maltese Cross atop engineering; it had overlayed itself about forty times. I have taken this as a sign from the Model God that He doesn't wish for a Maltese cross on this vessel at this time, and it has been removed; the model is functioning properly once more.

I'd also like to ask an opinion from some of our more literate users (who will surely bother to read this paragraph). In many of my Outcast ships I've added a dorsal anvil at the bow as well as the ventral one you see now. Should I remove the current wedge-like piece and add this anvil, or not? I haven't tried it yet, and I want opinions before I start acting rashly and delete large portions of an already-finicky model.

---

Quick comment - we thought that Panzer was the Leader, Swift. -Agmen

Which Dreadnought was that?

One of your nine.